logo

A Mathematical Model for the Mixed Lubrication of Non

If you want to confirm some technical details before you order,
just need to send a message or e-mail: [email protected].
Then our professional sales staff will contact you within 2 hours.

A computer model of mixed lubrication in point contacts .

A numerical model of mixed lubrication is presented in this paper. The idea introduced here is that asperity contact may be viewed as a result of a continuous decrease in film thickness, so that the transition between contact and non-contact is continuous and the same mathematical model should work for both regions.

Prediction on Lubrication and Friction of Mold Flux Based .

Following Newton law of viscosity, Coulomb law of friction and mixed lubrication theory, the mathematical model of mold flux lubricated and frictional behavior was proposed on the basis of considering different contact states between mold flux and strand surface, which could be used to discriminate and quantize lubricated behavior of mold slag ...

1. Introduction - Hindawi Publishing Corporati

Wei et al. [19] proposed a mathematical model including the Reynolds equation, the particle load carrying equation, the asperity contact equation, and the heat balance equation in order to simulate the mixed liquid-solid lubrication. The effects of the mixed liquid-solid lubricant, the particle diameter and mass concentration, the surface ...

A Mathematical Model for the Mixed Lubrication of Non-Conformable Contacts With Asperity Friction, Plastic Deformation, Flash Temperature, and Tribo-Chemist

A mathematical model is presented in this paper for rolling-sliding contacts operating in a mixed regime of elastohydrodynamic lubrication and boundary lubrication. The model is based on the framework of Johnson et al. (1972, “A Simple Theory of Asperity Contacts in Elastohydrodynamic Lubrication,” Wear, 19 , pp. 91–108).

A mathematical model of the hydro-support: An elasto .

Request PDF on ResearchGate | A mathematical model of the hydro-support: An elasto-hydrostatic thrust bearing with mixed lubrication | A mathematical model for a new type of navigation lock-gate ...

A mathematical model of the hydro-support: an elasto .

2. Model. The mathematical model of the hydro-support must describe a number of physical phenomena: • Track surface geometry. One of the typical properties of the hydro-support as studied in this paper, is the relative large surface waviness of one of the surfaces. • Mixed lubrication model. In the contact areas between bearing and track ...

Proc IMechE Part J: Effect of surface spacing parameters .

cially Pc, on average lubrication film thickness, ratio of contact area, ratio of contact load and non-dimen-sional maximum pressure are researched with the semi-system approach. Mathematical model According to the studies of Zhu and Hu,8 Wang et al.,9 and Hu and Zhu,10 a mathematical model is built for the mixed lubrication in point contacts. In

A computer model of mixed lubrication in point contacts .

Abstract. A numerical model of mixed lubrication is presented in this paper. The idea introduced here is that asperity contact may be viewed as a result of a continuous decrease in film thickness, so that the transition between contact and non-contact is continuous and the same mathematical model should work for both regions.

A computer model of mixed lubrication in point contacts .

A numerical model of mixed lubrication is presented in this paper. The idea introduced here is that asperity contact may be viewed as a result of a continuous decrease in film thickness, so that the transition between contact and non-contact is continuous and the same mathematical model should work for both regions.

A mathematical model for rolling/sliding line contacts in .

This paper presents a mathematical model for rolling/sliding line contacts operating in boundary and near boundary lubrication. The model is developed with first-principle formulations and incorporates key mechanical, thermal and tribo-chemical aspects of the problem including mode of deformation of the contact, friction, flash temperature, boundary film characterization and fluid–solid load ...

Penn State Engineering: MNE Directo

Liming Chang and Y. R. Jeng, 2014, "A mathematical model for the mixed lubrication of non-conformable contacts with asperity friction, plastic deformation, flash temperature and tribo-chemistry", ASME Journal of Tribology, 136, pp. 022301

MATHEMATICAL DESCRIPTION OF LUBRICATION FLOW BETWEEN ROUGH .

MATHEMATICAL DESCRIPTION OF LUBRICATION FLOW BETWEEN ROUGH SURFACES OF A PLAIN BEARING IN MIXED FRICTION V. V. KHARLAMOV, S. V. PAVLYSHKO Institute of Engineering Sciences, Ural Branch of the Russian Academy of Sciences, 34 Comsomolskaya st., 620219,

A Numerical Analysis for Piston Skirts in Mixed .

This paper presents a mathematical model for piston skirts in mixed lubrication. It takes into account the effects of surface waviness, roughness, piston skirt surface profile, bulk elastic deformation and thermal distortion of both piston skirts and cylinder bore on piston motion, lubrication and friction.

On the Stribeck Curves for Lubricated Counterformal Contacts of Rough Surfac

In the present study, numerical solutions in counterformal contacts of rough surfaces are obtained by using the unified deterministic mixed elastohydrodynamic lubrication (EHL) model recently developed.

Numerical investigation of tribological performance in .

Numerical investigation of tribological performance in mixed lubrication of textured piston ring-liner conjunction with a non-circular cylinder bore. ... A 2D mixed lubrication model, which consists of a generalized Reynolds equation ... Mathematical model 2.1. Ring surface texturing.

Journal Bearings Lubrication Aspect Analysis Using Non .

The aim of this work is related to an analysis of journal bearings lubrication using non-Newtonian fluids which are described by a power-law model. The performance characteristics of the journal bearings are determined for various values of the non-Newtonian power-law index “” which is equal to: 0.9, 1, and 1.1. Obtained numerical results show that for the dilatant fluids (), the load ...

Thermal and non-Newtonian analysis on mixed liquid–solid .

A mathematical model containing Reynolds equation, particle load carrying equation, asperity contact equation and heat balance equation is constructed to simulate the mixed liquid–solid lubrication.

Simulation of the effects of non-Newtonian fluid on the .

Proceedings of the Royal Society A: Mathematical, Physical & Engineering Sciences, 295(1442): 300–319. ... Streator JL, 2002. A model of mixed lubrication with ...

Penn State Engineering: ME Directo

Liming Chang and Y. R. Jeng, 2014, "A mathematical model for the mixed lubrication of non-conformable contacts with asperity friction, plastic deformation, flash temperature and tribo-chemistry", ASME Journal of Tribology, 136, pp. 022301

On a Model for the Prediction of the ... - SpringerLi

A model based on coupled contact approach was used by Bobach et al. to calculate friction in mixed lubrication. The half-space theory was employed to pre-calculate the dry mean contact pressure as a function of deformed gap height by assuming nominally flat surfaces in contact.